Having air conditioning installation performed correctly is essential, as units that are not properly installed may not operate at peak efficiency. This is not something you should attempt yourself, as this job can be complex and time consuming. Senica Air Conditioning, Inc. can perform air conditioning installation in Crystal River, FL. The first step in the installation process is to choose the right unit. During an initial consultation, a technician will take measurements of your home and ductwork in order to determine what size air conditioner you need. Once this has been determined, the technician will show you pictures of various models that meet your requirements and discuss the pros and cons of each one so you can make an informed decision. After choosing a unit, you’ll also need to find the right location for this equipment to sit. An HVAC technician will normally put a new unit in the same location where an older unit was located. If that location was in direct sunlight or near other hazards, air conditioning installation might need to be performed in a different area. A service technician will make sure the area is level and dry before proceeding with the installation process. The next step in air conditioning installation involves cutting a hole in the side of the building so that wires can be run through. This requires careful measuring and marking to ensure that pipes and existing wires are not damaged in the process. Once the hole has been cut, the new unit will be put into place so the rest of the installation can take place. It’s now time for the technician to make sure the evaporator coil, air handler, and suction line are all put into place properly. This could involve going into the crawl space of a home in order to stretch hose and wires across it. During this phase, it is essential for installers to check everything carefully before making any cuts, as these cannot be repaired if too much or too little material is removed. A disconnect box will need to be mounted to an outside wall. It is normally located near the air conditioning unit, and allows the power to be disconnected to the equipment in case of an emergency. This equipment must be installed to exact specifications in order for the homeowner to be in compliance with local building codes. One of the final steps in air conditioning installation is checking the unit. During this phase, a technician will turn on the air conditioner to make sure it is operating properly. At this time, you will be able to perform a final inspection of the contractor’s work and ask any questions you might have about the installation process or equipment. If you’re in Crystal River, Senica Air Conditioning, Inc. hopes you will give them a call whenever you decide to replace your existing unit. Our knowledgeable service technicians can install your equipment quickly and easily, so you will be feeling cool and comfortable in no time at all.
